Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By stefan-speliers
#43390
Hi,

with the new firmware everytime i start the engine (hot or cold) the rpm goes to 2400 when cold and even to 2800 when hot. it stays at that rpm for like 5 seconds and the goes to normal idle, to make sure its not a mechanical issue it tried the previous firmware and the problem is gone. I have looked at all the start up/idle settings and dont see a difference in settings between both firmwares.

Any ideas?
By Rob123456789
#43400
There's a new setting for "crank to run taper" in idle settings. Change it to 0 seconds and it should be back to normal. I had the same thing when I updated.
By stefan-speliers
#43406
Rob123456789 wrote:
Fri Jun 05, 2020 2:58 pm
There's a new setting for "crank to run taper" in idle settings. Change it to 0 seconds and it should be back to normal. I had the same thing when I updated.
I will try it this weekend.

Thanks for the response!

Can you post a toothlog ? I have 944 and it uses […]

Modified 3 cylinder

My grandson is taking electrical engineering a[…]

In my experience the problem only usually occurs[…]

3rz-fe turbo. help with iac valve

READ THE WIKI. https://wiki.speeduino.com/en/conf[…]

Still can't find what you're looking for?