- Fri Jul 26, 2019 9:08 pm
#36723
Well no luck...
Tried with 1uF on power line and 1000pf on signal line film type:
(yeah used some glue...) Than tried this DIS bobine:
Also didn't help.
Than tried using VR conditioner with VR2- to gnd.
Didn't output any signal.
Than tried with VR2- floating.
Did output but still with trigger failures: Can also be seen on composite logger: I don't know how this is happening.
The only easy solution would be to switch the speeduino to falling edge and to make sure the speeduino measures the time the signal is high. If it is below a certain threshold it should ignore the signal because it's noise. A trigger tooth is never such a short period.
Anyway I'm going from The Netherlands to Italy (1200km) on Sunday with the Speeduino. It works but without full sequential injection/ignition. Gonna tune the VE table some more tomorrow.
If anyone has any idea on how to solve this issue please let me know.
Tried with 1uF on power line and 1000pf on signal line film type:
(yeah used some glue...) Than tried this DIS bobine:
Also didn't help.
Than tried using VR conditioner with VR2- to gnd.
Didn't output any signal.
Than tried with VR2- floating.
Did output but still with trigger failures: Can also be seen on composite logger: I don't know how this is happening.
The only easy solution would be to switch the speeduino to falling edge and to make sure the speeduino measures the time the signal is high. If it is below a certain threshold it should ignore the signal because it's noise. A trigger tooth is never such a short period.
Anyway I'm going from The Netherlands to Italy (1200km) on Sunday with the Speeduino. It works but without full sequential injection/ignition. Gonna tune the VE table some more tomorrow.
If anyone has any idea on how to solve this issue please let me know.