New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By clubman
#41647
Hello,

Since I upgraded to 3.1.02 every time TS boots I get the following message (this is from the debug file):

:Warning: OfflineIniDownloader failed on signature: speeduino 201911, due to the error: File Avaliable for signature speeduino 201911

Can anyone solve that?

Thank you

i've read again the wiki, and not sure which hard[…]

Printing in PETG. PLA wouldn't stand a chance in[…]

Thanks for the positive feedback. I'll stick with […]

Noisymime has completed work on closed loop vvt fo[…]

Still can't find what you're looking for?